Mechanical CAD v1.1
Version 1.1 rebuilds the bike-light kit so it can go to a 3D printer: a magnet ring clamped to four spokes, a pickup on the fork leg with a ±4 mm slide, a front lamp on the bar that holds the two self-charging cells, and a rear lamp on the seat stay with an 8° rosette. Nothing is drilled into the frame. Every screw, insert and O-ring is in the model. The collision, loose-part, motion, spoke and overhang checks all pass. 21 of the 24 printed part types are ready for test prints. The ring carrier and the pickup housing need a decision on their 1.0 mm magnetic face walls, and the rear puck …
- Ready for test prints: 21 of 24 printed part types.
- Not ready: ring carrier MR-01 and pickup housing PU-01 (1.0 mm face wall by design), rear puck RL-01 (thin rim).
- No drilling: everything is held by clamps, TPU sleeves and security screws; one screw family M4 + M3 (M2 only for the boards).
- Ring clears the spokes by ≥ 1.91 mm on 28/32/36-hole radial and 3-cross wheels; the gap to the pickup stays 3.0 mm.